Plumbing Items You’ll Need

Plumbing supplies transport water from place to place in our houses and offices. Furthermore, these pipes also carry some other fluid like petrol or petroleum.

There are a variety of tools for the plumbing jobs performed by plumbers. Adjustable wrenches, basin wrenches, pliers, hacksaws and so on to get the work done quickly and safely.

Adjustable Wrenches
It’s about your tools, because you have to use them to do the job right. Some are generalists who can do most things, others may be specialized for certain work.

An adjustable wrench or spanner or crescent wrench has an adjustable jaw that can be resized. This is the best tool for unfastening and tightening fasteners.

Basin wrenches — basin wrenches, which are designed to be accessed under the sink and used to fix sink drain bolts, are more accessible than regular wrenches. It has a longer, angled head to get into hard-to-reach spots. Other plumbing tools like hex wrenches can turn sockets like on the faucet handles for more coverage where you need to reach an extreme location.

Pliers
Pliers are hand tools that you can use to solve all kinds of housework problems. Pliers are your go-to tool whether for holding objects securely or for cutting wires or metal with precision. Also, these little hand tools are great for clamping or twisting materials.

If you are equipped with the proper plumbing instruments, plumbing work will be much easier and less stressful. A few tools to try:

This handy tool from the plumber is made from a stretchy cable with a curled tip that can be used to sling hair, grease, and other materials out of drains easier and more securely than chemical solutions to remove clogs in your drains at home. There are various handles variants such as bare handles, plastic coated handles and two different versions of VDE insulation handles for convenience.

Hacksaw
Plumbers use hacksaws to make pipes. Its edge is sharp, however, and therefore users must be careful with it and keep it well fastened so that it will not dislodge or slip.

You can hacksaw steel bars, pipes, threaded rods; you can hack wood or plastics. They can be exchanged for the best results as per their design; tooth pitch, blade width, gullet depth & relief angle should be chosen. When choosing one with enough teeth to cut material specific materials.

Put your working tool in a clamp or in a vise before operating your hacksaw. Add a little machine oil too to stop friction & blade overheating.

Screwdriver
Screwdrivers are all-purpose hand tools to open or close screws. The right one for a particular screw will save its head from bending and the injury of slippage or over-intensity.

A screwdriver will often have a spherical shaft made of hard, tempered steel (so that it can’t be bent easily) and a soft-touch handle (such as cellulose acetate or thermoplastic rubber) for optimum grip and comfort.

Phillips head screwdrivers have a cross-tipped tip that can be used to push into the cross slot of philips screws for self-centering; there are hex screwdrivers which can be used to drive hex screws using electrical-power tools without the screwdriver heads tearing off their notches.

Tube Cutter
You must always have tools ready to use when you need to solve plumbing problems in an hour, and this is why plumbers usually keep tube cutters of all sizes in their tool boxes. – For pipes made from plastic, copper and brass — with a blade; heavier duty models with wheels to snip cast or tough iron and stainless steel pipes.

The majority of cutters specialized for metal pipes also work with plastic if your cutting wheel has been tuned for that material. Otherwise you might want to swap your blade.

When you’re using a tubing cutter, just pull on its knob for a few turns and then turn to cut. This will reduce the amount of pressure required to cut them, which is especially good as you have to use these tools frequently which would tire your hands in the long run.